Stainless Steel 80 Purified Water Dispenser

(0 reviews)

Get Price

(214) Views

(0) Contacts

Contact Company

Spring Water Treatment Limited Company

Izmir, Turkey

(1081) Views

(1) Contacts

Instructions

Ground the electrical supply connection of your water dispenser. Never operate the product in an ungrounded installation.
The cooling system of the water tank consists of an insulated aluminum pipe where the cooling gas is circulated and wrapped around the outside. The missing water is replenished by connecting it to the 0.3 Atm. pressure only potable water network with the help of the R 1/2 inlet float at the back of the tank.
Tank cleaning is achieved by opening the R 1/2 water drain plug located under the tank.
The waste water poured from the tap is discharged into the 10 litre plastic water tank located under the front chamber. This plastic tank needs to be emptied when it is full.
Do not try to turn the thermostat knob to the left when it is in position 0 or to the right when it is in position 7. These positions are the final positions of the knob. The device is off when it is in position 0 and works at maximum value when it is in position 7. The knob may break if forced.
When you first start up your industrial water dispenser, pay attention to the following points during the first 6 hours.
Your industrial water dispenser should not be subject to power outages.
The thermostat should not be set to off position.
It should not be operated empty without adding water.
If a power outage occurs within the first 6 hours, carefully follow the warnings under the heading "Things to do before calling authorized service".
It is recommended to operate the device in ambient conditions with temperatures between (+5 °C and +32.2 °C) and a maximum humidity of 65%.
In case of a device failure, only our Authorized Services have the authority to intervene. If a technical staff or unqualified personnel other than the Authorized Services intervene on the device, the device will be out of warranty .
For this reason, never allow unauthorized persons to intervene in the device. In such cases, the manufacturer cannot be held responsible in any way. During the service, our authorized services cannot be offered to use non-original spare parts for any reason. These non-original parts attached to the device in any way will void the device's warranty.

Cleaning and Maintenance

Empty the inner chamber of your water fountains completely every 30-40 days and disinfect them with chlorine.
After using 80 litre water dispensers or other industrial water dispensers, before cleaning them at regular intervals, disconnect the appliance from the electricity by unplugging it or turning off the fuse.
Never use steam or steam cleaning materials for cleaning, as in such a case, steam may come into contact with the live parts of the water dispenser and cause a short circuit or electric shock.
Clean 80 lt water dispensers or other industrial type water dispensers with a soft cloth or sponge dampened with liquid dishwashing detergent and warm water. To remove the detergent from the cabinet, wipe it with a clean cloth rinsed with warm water and dry it. Never use scratching and abrasive materials (such as thinner, bleach, powder detergent).
Be careful not to let water enter the control panel of the device during cleaning.
Since dust accumulated on the condenser will reduce the efficiency of the device, clean the condenser and its surroundings with a brush from time to time.